I am stumped as I want to code the car for my brother-in-law. I modified my cable with a switch and have 7 and 8 bridged to work with a E Do I need to change anything in the Ediabas configuration. Note on my first pic, I have a switch with 3 prongs, but I snipped off the 3rd one just to make it easier to solder…. Note which postion is on and which is off by some type of label on the outside of the cover…SImple! Screw in the 4 philip head screws in their respected holes. Once you locate pin 8, thats the pin we will be using as well as the next one over.Īt the end there will be one prong end not used…Neatly place the wires snug so that the D-can cover can be closed without anything preventing it to make a closed seal and your done. One side will have the digit 1 and the other digit 8. Locate pin 8 which will have a number on the side of the board. Some type of glue gun or glue adhesive 5.
Its actually very simple that any average person can do that has access to a drill and a soldering gun. Cost for this would probably range anywhere between 10 to 20 bucks. BMW Tools Package Software: INPA 5.06 - EDIABAS 7.3.0 - NCS Expert Dummy
